DESCRIBTION
-
A 4x3 matrix keypad and a 16x2 LCD have been used here. Keypad and LCD are very commonly used input & output devices, respectively. A four digit predefined password needs to be specified the user. This password is stored in the system.While unlocking, if the entered password from keypad matches with the stored password, then the lock opens and a message is displayed on LCD. Also an output pin is made high to be used for further purpose.The connections in the circuit are as following: port P2 of microcontroller AT89C51 is used as data input port which is connected to data pins (7-14) of LCD. P1^0, P1^1 and P1^2 pins of microcontroller are connected to control pins RS, RW and EN of LCD. Port P0 is used to take input from keypad. P0^7 has been used as lock output pin of controller.As the program starts, string ‘Enter Password’ is displayed on LCD. The keypad is scanned for pressed digits one by one. Every time, row and column of the key pressed is detected and a ‘*’ is displayed on LCD corresponding to the entered number. After the four digits are entered, the user is prompted to ‘Confirm Password’ and again the input is taken through LCD. If the passwords do not match, a message is displayed to indicate ‘Wrong Password’; otherwise the user is prompted to unlock the device.To unlock, user needs to ‘Enter Password’ through keypad. Again the keypad is scanned for pressed keys and corresponding digits are identified. The passkey is displayed as ‘****’ on the LCD screen. After the four digits are entered, they are compared with the pre-set password. If all the four digits match with set password, LCD displays ‘Lock Open’ and the lock output pin goes high. If the security code is wrong, ‘Wrong Password’ is sent to be displayed on LCD. The system gets locked if more than three attempts are made with wrong password to open the electronic lock. The system needs to be reset in such a case.
0 comments:
THANKS FOR UR COMMENT ....